Redline Communications Inc. AN30 用户手册

 

 

AN-30 System User Manual 

 

show config (List Configuration): Returns a list of all System Configuration 
parameters. 
 
show log (List the log file): Returns a list of current system log entries. 
 
show snmp (List SNMP Configuration): Returns a list of all SNMP communities and  
related parameters. 
 
show stats (List System Status): Returns a list of all System Status parameters. 
 
test config (Test System Configuration): Allows testing of configuration settings for 5 
minutes, after which the system reverts to the previously saved settings. To make settings 
permanent use 'save' command. 
 
upgrade (Software Upgrade): Begin a software upload. 
upgrade <ipaddr> <filename> 

 
 
 

 
To store the parameters into memory, the CLI Save Configuration command must be 
used. This operation is recorded in the System Logs.   
 
sysname (System Name): An alphanumeric identifier for the local terminal, which can 
consist of any combination of letters and numbers up to 20 characters in length.  The 
default name for the system from the factory is set to WEB01. The name remains with 
the system, even during power off states, until the operator re-types a new name using 
this menu field. 
 
sysdetails (System Details): Specifies the location of the unit, telephone number and/or 
contact information of the network administrator. Can be up to 20 characters in length.  
 
ipaddr (IP address): This field is used to provide an IP address for the local AN-30 
terminal.  The default address from the factory is 192.168.25.2.  For the initial setup, the 
terminal should not be connected to the Internet, i.e., the host computer should be 
connected directly to the terminal Ethernet port, to avoid address conflicts with other 
devices on a public network.  Once an IP address has been set, the terminal can be 
connected to the core network.   
 
ipmask (IP Subnet Mask): This field is used to set the desired IP subnet mask. The 
mask value is set to "255.255.255.0” (Class C subnet). 
 
gateway (Default Gateway Address):  Specifies the IP address of the default router / 
gateway on the local Ethernet segment. 
 

Page 31 of 80 

Redline Communications