Rhine Electronics Co Ltd 380T 用户手册
1/1
INSTRUCTIONS FOR OPERATION
RH380T LCD thermal remote control manual
SETING THE OPERATING CONTROLS
1.This unit operates on AAA 1.5 volts battery*4 (not included).(We use AAA battery*4)
To prevent possible damage if the battery should leak , be sure to remove
the battery when the unit is not use .
2. Store the controller away from excess heat or humidity .
3. This remote control unit is required with 16 code combinations. To prevent
To prevent possible damage if the battery should leak , be sure to remove
the battery when the unit is not use .
2. Store the controller away from excess heat or humidity .
3. This remote control unit is required with 16 code combinations. To prevent
possible interference from or to other remote units such as garage door
openers, car alarm or security system . If you find that your fan and light
kit go on and off without using your control , simply change the combination
code in your transmitter and receiver .
openers, car alarm or security system . If you find that your fan and light
kit go on and off without using your control , simply change the combination
code in your transmitter and receiver .
4.Operation buttons on the panel of transmitter .
FAN key – For fan speed control
甲、
6
à5à4à3à2à1à2à3 Cycle Operation
乙、
ON
ßàOFF
FAN/REV key – Fan reverse control
LIGHT DOWN key – For down light brightness and ON/OFF control .
LIGHT UPPER key – For upper light brightness and ON/OFF control .
LEARN key (SET) – Setting for learn code
LIGHT DOWN key – For down light brightness and ON/OFF control .
LIGHT UPPER key – For upper light brightness and ON/OFF control .
LEARN key (SET) – Setting for learn code
5.Start the fan and Turn off the fan:
Press the selected speed button to run the fan at the desired .
Press the FAN button over 0.7 second for adjusting the ceiling fan speed. Press within 0.7
second for ON/OFF control.
Press the FAN button over 0.7 second for adjusting the ceiling fan speed. Press within 0.7
second for ON/OFF control.
6.Light control :
Turn the light on or off by only touching the LIGHT CONTROL button .
Keep pressing the button in excess of 0.7 second it becomes a dimmer ,
the light varies cyclically in 0.8 second .
Keep pressing the button in excess of 0.7 second it becomes a dimmer ,
the light varies cyclically in 0.8 second .