Rhine Electronics Co Ltd 9787T 用户手册

1/2

INSTRUCTIONS FOR OPERATION

SETING THE OPERATING CONTROLS

This unit operates on a 12 volts battery (not included).

To prevent possible damage if the battery should leak , be sure to remove
the battery when the unit is not use .

Store the controller away from excess heat or humidity .

This remote control unit is required with 2

code combinations. To prevent

possible interference from or to other remote units such as garage door openers, car alarm

or security system .

4. Operation buttons on the panel of transmitter .

key – For fan Maxsmum speed .

key – For fan High speed .

key – For fan Medium speed .

III key – For fan Low speed .
II

key – For fan Lower speed .

I key – For fan Minimum speed .

■

key – For fan speed off .

REV key – For fan speed Reverse .

UP LIGHT CONTROL key – For light brightness and ON/OFF control .
DOWN LIGHT CONTROL key – For light brightness and ON/OFF control .

Start the fan :

Press the selected speed button to run the fan at the desired .

Turn off the fan :

Press the OFF button .

7. Light control :

Turn the light on or off by only touching the LIGHT CONTROL button .
Keep pressing the button in excess of 0.7 second it becomes a dimmer ,

the light varies cyclically in 0.8 second .

One of the important feature of this control is AUTO-RESUME . After power
on , it allows the light return to where it was off .

INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED CONTROLLER

1.SAFETY PRECAUTIONS：

1.WARNING：HIGH VOLTAGE：Disconnect source of electrical power by removing fuse

or switching off circuit breakers.

2.Do not use with solid state fans.
3.Electrical source and fan must be 120 volt, 60/50Hz. Maximum fan

motor amps:1 Maximum light watts:360-incandescent (or Ballast
300VA)

4.Household electrical power can cause serious injury or death.