Eaton 9135 UPS PPDM EPPDMG6000-3U-3 用户手册
产品代码
EPPDMG6000-3U-3
INSTALLATION
EATON Two-in-One PPDM (5000/6000 VA) User's Guide
S
164201820 Rev 1 www.eaton.com/powerquality
28
Input Voltage
(from UPS)
EPPDMG-6000-3U-6 (L6-30) and EPPDMG-6000-3U-7 (L6-20) Models Output Voltage
208V Switch Position
Default 240V Switch Position
L6-30R or L6-20R
5-20R
L6-30R or L6-20R
5-20R
208
208
120
208
104
220
220
126
220
110
230
230
131
230
115
240
240
136
240
120
4.
Neutral-to-Ground Bonding. The PPDM has a neutral-to-ground (N-G
or neutral-to-earth) bonding screw as required under safety
regulations issued by various regulatory agencies. If the
neutral-to-ground connection is not needed, remove the screw to
remove the bond between neutral and ground.
or neutral-to-earth) bonding screw as required under safety
regulations issued by various regulatory agencies. If the
neutral-to-ground connection is not needed, remove the screw to
remove the bond between neutral and ground.
See “Plug-Receptacle PPDM Rear Panels” on page 31 for the
neutral-to-ground screw locations.
neutral-to-ground screw locations.
5.
Continue to the following section, “PPDM Startup.”
PPDM Startup
To start up the PPDM with a 9135 UPS, continue to the following
section, “9135 UPS Startup.”
section, “9135 UPS Startup.”
UPS Startup
To start up the PPDM with a 9135 UPS:
1.
If you are installing a remote power-off (RPO) switch, install the
switch before powering on the UPS. Refer to “RPO Installation” in
the UPS user's guide for instructions.
switch before powering on the UPS. Refer to “RPO Installation” in
the UPS user's guide for instructions.
2.
Refer to the UPS user's guide for recommended upstream
protection. For EU models, also refer to the recommendations for
downstream protection.
protection. For EU models, also refer to the recommendations for
downstream protection.
3.
Plug the input and output cords of the PPDM into the input and
output power connectors on the UPS power cables (see Figure 13).
output power connectors on the UPS power cables (see Figure 13).