Toshiba CTX IPT/DKT 用户手册
IPT2010-SDC
IPT2010-SDC Programming
86
Strata CIX and CTX IPT/DKT Telephone 08/07
IPT2010-SDC Programming
Important!
The IPT2010-SDC must be programmed, using eManager, as a 20
button station (Prog. 204). Feature Button 11 (FB11) must be
programmed as a Release button. When the ACO button is pressed the
IPT2010-SDC sends Hold and FB11 (Release) to the CIX system.
button station (Prog. 204). Feature Button 11 (FB11) must be
programmed as a Release button. When the ACO button is pressed the
IPT2010-SDC sends Hold and FB11 (Release) to the CIX system.
FB12 ~ FB20 must be blank.
The feature button used as the ACO must be blank (no assignment) in
the CIX data base (Prog. 205).
the CIX data base (Prog. 205).
The programming, shown below, must be done at your IPT2010-SDC telephone. This
procedure shows only the programming unique to the IPT2010-SDC. For all other
programming functions refer to the DKT/IPT Administrator Guide.
procedure shows only the programming unique to the IPT2010-SDC. For all other
programming functions refer to the DKT/IPT Administrator Guide.
To place your telephone in Programming Mode
1. Press
3
+
6
+
9
+
Hold
simultaneously. The LCD displays “PROGRAM MODE” and
“SELECT=”
2. Press
4
, then press
Hold
.
Note
Your phone will not ring if it receives a call while in Programming Mode.
Place the phone into programming mode then set the following:
Note
Typically, FB20 ~ FB09 will be left at factory default. However, if necessary,
use the Scroll key (SK3) to access FB11 through FB20.
use the Scroll key (SK3) to access FB11 through FB20.
1. Press FB01 – ACO Button position. Enter the button position, then press Hold.
Go to the next Step or, if you are finished programming, go to
Enter 1 ~ 10 (Default = 10, FB10)
2. Press FB02 – ACO privacy (Privacy override is not available). Enter the ACO
privacy value, then press Hold. Go to the next Step or, if you are finished
programming, go to
programming, go to
.
1 for No privacy (default) – other IPT2010-SDC with the same ACO can access the
CO line while it is in use.
CO line while it is in use.
2 for Privacy – other IPT2010-SDC with the same ACO cannot access the CO line
while it is in use.
while it is in use.
3. Press FB03 – ACO Ringing assignment. Enter the ring assignment then press
.
2 = Ring (Default)
1 = No ring
1 = No ring