Toshiba DKA-AG-SYSTEMVD 用户手册
Setting System Parameters
Night Transfer
Strata DK System Administrator Guide 5/00
9
Night Transfer
Incoming calls to your system can be made to route and ring different destinations,
based on either two- or three-call routing (ringing) patterns (set in system
programming). The Night Transfer LED indicates the active routing pattern:
based on either two- or three-call routing (ringing) patterns (set in system
programming). The Night Transfer LED indicates the active routing pattern:
Night Transfer can be locked by pressing
17/RFNa
and dialing the NT Lock
password (see the procedure outlined on the following page).
If the system has tenant service, up to four Tenant Night Transfer buttons (
1LJKW
7UDQVIHUa
) can be assigned and controlled independently.
➤ To enable/disable night transfer
➤
Press
1LJKW7UDQVIHU
to toggle night transfer ON/OFF.
Night Transfer Lock/Unlock Password
The Night (NT) Lock/Unlock mode enables the Administrator’s station or an
attendant console to lock the system into the Day, Day 2, or Night mode. By setting
the system into different modes, incoming CO calls can be routed to different
destinations.
attendant console to lock the system into the Day, Day 2, or Night mode. By setting
the system into different modes, incoming CO calls can be routed to different
destinations.
In order for the Administrator station or the attendant console to perform such routing,
it must be assigned with
it must be assigned with
1LJKW7UDQVIHU
and
17/RFN
buttons via system
programming. Up to four
1LJKW7UDQVIHU
and
17/RFN
buttons are allowed.
Check with the system installer for any additional information.
Mode
Three-pattern
Two-pattern
DAY
OFF
OFF
DAY 2
FLASH
N/A
NIGHT
ON
ON