Jeti 9-channel receiver 2.4 GHz FHSS with Connector system JR 80001224 用户手册
产品代码
80001224
computer radio control system
EN
transmitter. Select this setup for the model‘s main receiver. Use the
same setup if you use only one receiver in your model (if you are
using only one DUPLEX receiver for remote control).
same setup if you use only one receiver in your model (if you are
using only one DUPLEX receiver for remote control).
Clone - unidirectional communication. If you are using several
DUPLEX receivers in the model, for instance, in connection with one
redundant transmitter module then you should operate one of the
receivers in „Normal“ mode and the others in „clone“ mode. The
receiver operating in „Normal“ mode is considered to be the main
receiver. One of the transmitter modules is able to control only one
receiver in „Normal“ mode. If you want to operate several receivers
with only one transmitter module, you should operate them in
„clone“ mode.
DUPLEX receivers in the model, for instance, in connection with one
redundant transmitter module then you should operate one of the
receivers in „Normal“ mode and the others in „clone“ mode. The
receiver operating in „Normal“ mode is considered to be the main
receiver. One of the transmitter modules is able to control only one
receiver in „Normal“ mode. If you want to operate several receivers
with only one transmitter module, you should operate them in
„clone“ mode.
Bind process in „clone“ mode (Attention, change since FW
version 3.10!):
version 3.10!):
1.
Switch the receiver to „clone“ mode (MeasureOrSetting-
>Main Setting->RX mode: „clone“).
2.
Switch-off the receiver and insert a bind plug into the EXT
socket.
3.
Switch-on receiver and transmitter. The transmitter announces
by an acoustic signal detection of a new receiver. Remove the
bind plug.
Telemetry* -unidirectional communication is usable exclusively for
telemetry transmission, for instance, with the US version of the
JETIBOX profi
telemetry transmission, for instance, with the US version of the
JETIBOX profi
This setup change requires a longer pressing (press and hold) of the left
or right push button. The receiver mode change is only accessible via
or right push button. The receiver mode change is only accessible via