Jeti 11-channel receiver 2.4 GHz FHSS with Connector system JR 80001225 用户手册
产品代码
80001225
computer radio control system
EN
the JETIBOX, see the „Receiver setup“ chapter.
If you switch the receiver to „clone“ or „Telemetry“ modes, further
wireless setup communication becomes impossible, because the
receiver is now communicating only unidirectionally. In order to
change the mode or setup you have to connect the JETIBOX to the
receiver and make the desired change or switch the receiver to back
to„Normal“ mode:
wireless setup communication becomes impossible, because the
receiver is now communicating only unidirectionally. In order to
change the mode or setup you have to connect the JETIBOX to the
receiver and make the desired change or switch the receiver to back
to„Normal“ mode:
1.
Insert BIND PLUG into the receiver socket labeled EXT.
2.
Switch-on receiver
3.
Switch-on transmitter;
4.
Execute the desired setup changes, see „Receiver setup“
* Setup valid only for US version receivers.
6.4 Out Pin Set
Setup of the physical receiver outputs.
Set Output pin - selection of output, which goes for the following
set-up. The menu item shows, as a decimal number, the throw of the
selected output. Receiver output 1 is labeled as Y1.
set-up. The menu item shows, as a decimal number, the throw of the
selected output. Receiver output 1 is labeled as Y1.
For the R9, R10, R11EPC, R12EPC, R14 and R18 receivers, some of
the outputs may be assigned (see the table of receiver output
assignments) to alternative functions. Description of alternative
functions:
- standard servo output: assigned to the output is the throw of an
actual channel, which uses the standard servo output form and is
the outputs may be assigned (see the table of receiver output
assignments) to alternative functions. Description of alternative
functions:
- standard servo output: assigned to the output is the throw of an
actual channel, which uses the standard servo output form and is