Jeti 11-channel receiver 2.4 GHz FHSS with Connector system JR 80001225 用户手册
产品代码
80001225
computer radio control system
EN
3.1 Voltage Supply
When designing the on-board wiring for you project always pay
attention to the voltageinput range of your receivers and servos.
You can supply voltage to DUPLEX receivers as follows:
attention to the voltageinput range of your receivers and servos.
You can supply voltage to DUPLEX receivers as follows:
- Directly from the batteries
- Via a BEC voltage regulator (either contained in speed
controllers or self contained)
The supply may be connected to DUPLEX receivers via:
- the throttle channel (when applying speed controllers with BEC)
- a free receiver output.
Do not use the „EXT“ input for
connecting the voltage supply!
- an Y-cable to any arbitrary receiver output (other than the
„EXT“)
- the MPX connector for receivers with the EPC label or the R14
and R18 receivers which are equipped with a power supply
connector
3.2 Operation
We recommend that you switch-on the transmitter first and then
subsequently the receiver. The transmitter confirms the switching-
on of the receiver with an acoustic signal. When switching-off the
system we recommend that you switch-off the receiver first and
then subsequently proceed with switching-off the transmitter.
subsequently the receiver. The transmitter confirms the switching-
on of the receiver with an acoustic signal. When switching-off the
system we recommend that you switch-off the receiver first and
then subsequently proceed with switching-off the transmitter.
3 Overview