Reely 1:10 Deathwatcher 4WD TC-04 RtR 2.4 GHz FS53101 M 数据表





The vehicle body is secured with holding clips which must be pulled out from the retaining pins. The vehicle body can
then be lifted off.

Unwrap the aerial cable completely and smooth it out carefully. For this, hold the aerial cable near the receiver with two
fingers (do not hold the receiver but the cable) and then pull the cable straight with two fingers of your other hand
(repeatedly if necessary).

Then insert the aerial cable from below through the attachment at the vehicle.

Guide it through the aerial tube and plug the aerial tube into the attachment mount on the vehicle. Simply let excess
aerial cable protrude loosely from the tip of the aerial tube.

If a rubber cap for the aerial tube is enclosed; it prevents the dislocation of the aerial cable after it is attached to the tip.

Make sure that the aerial cable does not protrude into the drive or touch the cardan shaft! It is normally
sufficient to slightly tighten the cable or fix it in place with a cable binder.

Never shorten the aerial cable! Never roll up the aerial cable! This greatly reduces the range!

Open the battery compartment on the transmitter and insert new batteries or fully charged rechargeable batteries.
Observe correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment
again.

Switch on the transmitter. Check the functions at the transmitter.

Observe the enclosed operating instructions for the remote control system.