Renkforce R-2000U STEREO-RECEIVER 29265c4 数据表

When selecting the set-up location, please take into consideration the room layout such as the where-

abouts of the nearest socket, etc.
When selecting the set-up site, observe that direct sunlight, vibration, dust, heat, cold and moisture must

be avoided. There also must not be any strong transformers in the device‘s proximity.

 

Only operate the device on a stable, horizontal surface. There must be enough air circulation to 

permit dissipation of the generated heat. Therefore, only place the device on a level surface and 

not on carpets, etc. Do not cover up the ventilation slots in the casing.

 

Non-observance of this note may cause damage to the device.

 

Do not drill or turn any additional screws into the casing to mount the device. This damages the 

device and it may become possible to touch potentially fatal mains voltage.

 

Only operate the receiver in a horizontal position, since heat may accumulate otherwise.

 

Make sure you position the device safely. Falling devices may pose a significant risk of acci-

dent.

 

Place the mains cable and all other connected cables where no one can trip over it.

  Due to the diversity of surfaces and furniture paints and polishes used, it is possible that the 

device‘s feet will leave visible residue on furniture due to chemical reaction. Pressure spots may 

be caused by the weight as well.

 

The device therefore should not be placed on valuable furniture surfaces without any suitable 

protection.

Open the battery compartment on the rear of the IR remote control and insert two type AAA/Micro batteries 

with correct polarity (observe plus/+ and minus/-). Close the battery compartment again.

  If the range of the IR remote control reduces or the receiver no longer reacts to the control com-

mands of the IR remote control, replace the batteries by new ones.

 

Observe that some buttons of the IR remote control are not used for the receiver but for the CD 

player of the same manufacturer.