ABUS 2-Zone alarm system Conrad Alarm zones 2 Conrad 数据表

When choosing the alarm system’s installation site, observe precisely that the alarm
system can be reached before the end of the entry delay (within 30 seconds).
Depending on installation site, it may be a good idea to additionally secure the
installation site via a signalling device (e.g. motion detector).

When selecting an installation location for your system, make sure it is not exposed
to direct solar radiation, vibrations, heat, cold and moisture.

Before actually mounting the alarm control centre and its components you should
use a blueprint of the premises to be protected to create a plan and then record this
plan, e.g. as a sketch on paper, to record how your object can be best and individu-
ally secured. Draw in the sensors of the doors, windows, rooms etc to be secured.
Observe the characteristics of the individual sensors (e.g. detection angle of a
movement sensor). This sketch allows you to estimate the possible materials
requirements (e.g. length and lead number of cables, number of movement sen-
sors, door/window sensors etc).

After finding a suitable assembly site, the alarm system can be installed. 

• The alarm system is fastened to

the wall by means of two screws.
For this, the alarm system has two
mounting holes (see figure to the
right).

27

Mounting holes: