Bosch Appliances Home Security System D1260B 用户手册
D1260/D1260B | Owner's Manual | Part II: System Commands - RESET SENSORS ? (COMMAND + 4 + 7)
Bosch Security Systems | 9/04 | 50410D
27
RESET SENSORS ? (COMMAND + 4 + 7)
Reset Sensors
Description
Detection devices, such as smoke detectors and shock
sensors, must be reset after being activated. This
function momentarily removes power from these
sensors to reset them.
sensors, must be reset after being activated. This
function momentarily removes power from these
sensors to reset them.
It also clears point information from the display,
leaving the *
leaving the *
ALARM SILENCED
*
message in the
display as a reminder that the View Memory function
can be used to view the cleared point information.
can be used to view the cleared point information.
To clear the event memory and remove the *
Alarm
Silenced*
message from the display, press the
Clear
Display> soft key.
The display will show the instructions for clearing the
message. Enter a valid passcode and press the
message. Enter a valid passcode and press the
Clear>
soft key.
Arming the system will also clear the display and the
event memory.
event memory.
Using Reset Sensors:
1.
The display shows disarmed idle text.
2.
Press the
COMMAND key. The display shows
*System Command*
.
3.
Press the
4 key, followed by the 7 key.
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu.
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the RESET SENSORS
?> prompt, press its adjacent soft key.
?> prompt, press its adjacent soft key.
Press ENTER.
4.
The display shows for approximately 15 to 20
seconds.
seconds.
The display then shows retrieving the panel
information.
information.
The display then returns to show idle text.
If you enter this function and the detector or sensor
resets momentarily, but then returns to a faulted
condition, the conditions causing the activation may
still be present or the detector may be faulty. Check to
be certain that there is no smoke, fire, or other danger
present. If you can’t reset the detector or sensor contact
your security company.
resets momentarily, but then returns to a faulted
condition, the conditions causing the activation may
still be present or the detector may be faulty. Check to
be certain that there is no smoke, fire, or other danger
present. If you can’t reset the detector or sensor contact
your security company.