Elitegroup 945GCT-M3 用户手册
39
Using BIOS
Press <Esc> to return to the Integrated Peripherals page.
IDE DMA transfer Access (Enabled)
This item allows you to enabled the transfer access of the IDE DMA.
On-Chip Primary/Secondary PCI IDE (Enabled)
The integrated peripheral controller contains an IDE interface with support for
two IDE channels. Select Enabled to activate each channel separately.
The integrated peripheral controller contains an IDE interface with support for
two IDE channels. Select Enabled to activate each channel separately.
IDE Primary/Secondary Master/Slave PIO (Auto)
Each IDE channel supports a master device and a slave device. These four items let
you assign which kind of PIO (Programmed Input/Output) is used by IDE devices.
Choose Auto to let the system auto detect which PIO mode is best, or select a PIO
mode from 0-4.
you assign which kind of PIO (Programmed Input/Output) is used by IDE devices.
Choose Auto to let the system auto detect which PIO mode is best, or select a PIO
mode from 0-4.
IDE Primary/Secondary Master/Slave UDMA (Auto)
This mainboard supports UltraDMA technology, which provides faster access to IDE
devices. If you install a device that supports UltraDMA, change the item on this list
to Auto. You may have to install the UltraDMA driver supplied with this mainboard
in order to use an UltraDMA device
devices. If you install a device that supports UltraDMA, change the item on this list
to Auto. You may have to install the UltraDMA driver supplied with this mainboard
in order to use an UltraDMA device
SATA Mode (IDE)
Use this item to select the mode of the Serial ATA.
On-chip Serial ATA (Auto)
Enables and disables the built-in on-chip serial ATA.
SATA PORT Speed Settings (Disabled)
This item is used to select SATA I or SATA II device support forcedly.
This item is used to select SATA I or SATA II device support forcedly.
PATA IDE Mode (Primary)
This item is used to set the PATA IDE mode. When set to Primary, P1 and P3 are
Secondary; on the other hand, when set to Secondary, P0 and P2 are Primary.
This item is used to set the PATA IDE mode. When set to Primary, P1 and P3 are
Secondary; on the other hand, when set to Secondary, P0 and P2 are Primary.