Galil DMC-2X00 用户手册

下载
页码 267
30  
  Chapter 6  Programming Motion 
DMC-2X00  
 
 
Figure 1 Position vs Time (msec) Motion 1 
Example  
Motion 2:   
The previous step showed the plot if the motion continued all the way to 5000, however partway 
through the motion, the object that was being tracked changed direction, so the host program 
determined that the actual target position should be 2000 cts at that time.  Figure 2 shows what the 
position profile would look like if the move was allowed to complete to 2000 cts.  The position was 
modified when the robot was at a position of 4200 cts.  Note that the robot actually travels to a distance 
of almost 5000 cts before it turns around.  This is a function of the deceleration rate set by the DC 
command.  When a direction change is commanded, the controller decelerates at the rate specified by 
the DC command.  The controller then ramps the velocity in up to the value set with SP in the opposite 
direction traveling to the new specified absolute position.  In figure 3 the velocity profile is triangular 
because the controller doesn’t have sufficient time to reach the set speed of 50000 cts/sec before it is 
commanded to change direction.