Behringer Feedback Destroyer FBQ1000 用户手册

FEEDBACK DESTROYER FBQ1000 User Manual

As a standard, the audio inputs and outputs on the BEHRINGER FEEDBACK 

DESTROYER are fully balanced. If possible, connect the unit to other devices in a 

balanced configuration to allow for maximum interference immunity.

For connection of balanced and unbalanced plugs,

ring and sleeve have to be bridged at the stereo plug.

For unbalanced use, pin 1 and pin 3 

have to be bridged

1 = ground/shield

2 = hot (+ve)

3 = cold (-ve)

1

2

3

1

2

3

Fig. 10.1: Different plug types

Connect the insert send with the input and the

insert return with the output of the effects device.

Fig. 10.2: Wiring an insert cable

The MIDI connectors found on the rear panel are on internationally standardized 

5-pin DIN jacks. You need dedicated MIDI cables to connect the FEEDBACK 

DESTROYER to other MIDI equipment. Normally, complete cables will be 

purchased for this use, but you can also make your own, using a high-quality 

two-conductor shielded cables (e.g. microphone cable) and two rugged 180° 

DIN plugs: pin 2 (center) = shield, pins 4 and 5 (right and left of pin 2) = internal 

conductors, pins 1 and 3 (the two outer pins) are not used. MIDI cables should 

have a maximum length not exceeding 15 meters.
MIDI IN: Receives MIDI control data. The receive channel is determined in the 

SETUP menu.
MIDI THRU: Provides an unchanged copy of the signal received at the MIDI IN, 

for example, to daisy-chain several FEEDBACK DESTROYER.
MIDI OUT: Transmits MIDI data to a connected computer or other 

FEEDBACK DESTROYER. Transmitted are program data as well as status 

information for signal processing.