Bunn Beverage Dispenser DV 用户手册

13

Location:

The safety overflow switch is located inside the rear of 

the dispenser inside the copper overflow cup.

For testing or removal of the safety overflow switch, 

access may also be needed by removing the two screws 

attaching the electronic control assembly to its mount-

ing bracket.

Test Procedure:

1.  Once voltage is verified at the power source, check 

for continuity across the safety overflow switch 

red wires only until the plastic float is raised and 

check that continuity returns when the plastic float 

is again lowered.

If continuity is present as described, reconnect each 

of the red wires to the black wires, the safety overflow 

switch is operating properly.

If continuity is not present as described, replace the 

safety overflow switch.

FIG. 13a SAFETY OVERFLOW SWITCH

FIG. 13c SAFETY OVERFLOW WIRING

This

 eq

uipm

ent

 is to 

be 

ins

talle

d to

com

ply wi

th the

 Bas

ic P

lum

bing

 Co

de 

of

the 

Bui

lding

 Of

ficia

ls a

nd 

Cod

e

Adm

inistr

ators

 Inte

rna

tion

al, In

c. (B

OC

A)

an

d th

e Food

 Ser

vice

 Sani

tation

 Ma

nua

l

of th

e Food

 and 

Dr

ug 

Adm

inistr

atio

n (F

DA

).

RED to BLK Wire from 

Terminal Block

RED to BLK Wire from Elec-

tronic Control #3

P4093

P1777

Removal and Replacement:

1.  Disconnect the black wires from the safety overflow 

switch.

2.  Remove the nut beneath the copper overflow cup.

3.  Remove the entire switch assembly from the cup.

4.  Place the new switch assembly into the cup, wires 

first. Make sure that a gasket is in place around the 

threaded switch stem.

NOTE - The magnets must be at the top of the float and 

there must be NO stainless steel washers installed for 

the safety overflow switch to operate properly.

5.  Install the nut beneath the copper overflow cup.  

Be sure not to overtighten.

6.  Reconnect the wires, FIG. 6.

P1993

FIG. 13b OVERFLOW PROTECTION  SWITCH

42311 071310