Bunn AF PR-3 用户手册

9

FIG. 4 FUSE HOLDER

P1561

Location:

The fuse holder is located on the lower right

front of the autofill box just to the left of the power
cord.

Test Procedure:
1. Disconnect the dispenser from the power source.
2. Remove cap and fuse from fuse holder.
3. Remove fuse from the cap.
4. Check for continuity through the fuse.

If continuity is present as described, reinstall the fuse,
the fuse is operating properly.
If continuity is not present as described, replace the
fuse.

28791.1 011500

WHI/GRN from Main 
Harness/ON/OFF Switch

WHI/GRN from Main 
Harness/Control Board

BLK from Main
Wiring Harness

BLK to Main
ON/OFF Switch

FIG. 5 FUSE HOLDER TERMINALS

P1331

Removal  and Replacement:
Fuse:
1. Remove the cap from the fuse holder.
2. Remove fuse from the fuse holder, inspect, if

blown discard.

3. Install new 10 amp fuse in the fuse holder.
4. Reinstall fuse holder cap.

Fuse Holder:
1. Disconnect the wires from the rear of the fuse

holder.

2. Remove the nut securing the fuse holder to the

front of the main mounting panel.

3. Push the fuse holder through the hole in the panel.
4. Install new fuse holder and fuse through the hole

in the panel.

5. Secure the fuse holder to the panel.
6. Refer to Fig 5 and reconnect the wires.