IntraServer Technology 5232E 用户手册
31
Table 6 Adapter to Network Hub Wiring
Connection from the ITI-5232E adapter to another network adapter (point to point) must
be made as shown in Table 7:
be made as shown in Table 7:
Crossover
Adapter 1
Pin
Adapter 2
Pin
TX (+)
1
ÇÈ
3
RX (+)
TX (-)
2
ÇÈ
6
RX (-)
RX (+)
3
ÇÈ
1
TX (+)
4
4
5
5
RX (-)
6
ÇÈ
2
TX (-)
7
7
8
8
Table 7 Adapter to Adapter (point to point) Wiring
Cabling Requirements
In order for your network to operate properly, you must use a category of network cabling
that is appropriate for the data rate of the channel. For 10Mb/s operation, Category 3, 4
or 5 cable is appropriate. When operating in 100Mb/s or 100Mb/s Full Duplex, a
Category 5 cable should be used.
that is appropriate for the data rate of the channel. For 10Mb/s operation, Category 3, 4
or 5 cable is appropriate. When operating in 100Mb/s or 100Mb/s Full Duplex, a
Category 5 cable should be used.
The maximum cable segment length supported at 100Mb/sec speed, on Category 5 cable
is 100M. Any single cable segment (adapter to adapter or adapter to network hub) must
be within the 100M length requirement.
is 100M. Any single cable segment (adapter to adapter or adapter to network hub) must
be within the 100M length requirement.