Rockford Fosgate IB-200 用户手册



Vehicle Installation

CAUTION: Due to the requirements of how the IBeam tactile transducer 

needs to be mounted in a vehicle, we strongly  

recommend it be installed by a  

qualified Rockford Fosgate technician.

For best performance, the IBeam  
should be mounted to the  
underside frame of the seat.

If your seat does not allow for  
proper mounting, the IBeam  
can be mounted under the  
center console.

Where ever you end up  
mounting your IBeam, make  
sure all surrounding items are mounted  
firmly and tight. If not, these items will rattle when the IBeam is working.

CAUTION: Before installation, disconnect the battery negative (-) terminal 

to prevent damage to the unit, fire and/or possible injury.

The IBeam can be powered by any 4 ohm stable amplifier that provides a minimum of  
100 Watts RMS @ 4 ohms.  Amplifiers with 150 – 250 Watts @ 4 ohms offer the best  
experience. 

1.  Pre-route 16/14 or 12AWG speaker wires from the IBeam unit to the amplifier it will be 

connected to.

CAUTION: 

Be sure to route wires were they will not be damaged due to sharp 
edges or from the movement of the seat.

2.  Connect the speaker wires to the IBeam and mark them to maintain proper signal polarity 

when connecting to the amplifier.

3.  Follow the instructions provided with the amplifier being used to connect it to the vehicle 

system.

4.  Connect the speaker wires from the IBeam to the output on the amplifier. Be sure to main-

tain proper signal polarity for best performance.

5.  For best performance set the amplifier to low pass (LP) with a crossover setting of  

100-300hz.

PUSH

Speaker connection from amplifier.

Multiple IBeam system.

To insert

wire

 Be sure to mantain signal polarity.

2

1