Pioneer Industrial DDJ-ERGO-K 用户手册

下载
页码 31
21
En
Advanced 
Operation
Advanced Operation
Using the CUE function
1  In the pause mode, press the [CUE] button to set a cue 
point at the position at which playback is paused.
2  When the [CUE] button is pressed during playback, 
playback returns to the cue point that was set directly 
before and pauses (Back Cue).
3  After returning to the cue point, keep pressing the 
[CUE] button to continue playing (Cue Sampler).
Using the LOOP function
Manual looping
1  During playback, press the [IN] button to set the loop 
in point.
2  Press the [OUT] button to set the loop out point and 
start loop playback.
!  When the [OUT] button is pressed during loop playback, loop play-
back is canceled.
Auto looping
1  During playback, turn the [AUTO LOOP] control to set 
the length for loop playback in number of beats.
2  Press the [AUTO LOOP] control to start loop playback.
!  The length of the loop can be changed by turning the [AUTO LOOP
control during loop playback.
!  When the [AUTO LOOP] control is pressed during loop playback, 
loop playback is canceled.
Using the EFFECT function
Separate audio effects can be applied to the respective decks.
1  Turn an effect parameter control while pressing the 
[SHIFT] button to select the effect type.
2  Press an effect parameter button.
3  Turn the effect parameter controls to adjust the 
parameters of the respective effects.
Switching the jog dials’ illumination 
mode
This unit is equipped with two types of illumination modes for the jog 
dials.
Press the [VINYL (PULSE MODE)] button while pressing 
the [SHIFT] button to switch the illumination mode.
—  Pulse Mode Active: The offset of the beat grid is indicated by the 
white illumination of the jog dials. The illumination is brightest 
for the master deck and decks for which the beat grid matches. 
The jog dials’ illumination also lights in association with the 
operation of the [FILTER] control.
—  Pulse Mode Normal: The white illumination lights when the top of 
the jog dial is pressed.
!  The illumination mode setting is not cleared when this unit’s power 
is turned off. When the power is next turned on, the unit starts in the 
mode that was set before the power was turned off.