Perle Systems 5500208-43 用户手册

 34

Configuring Users

  

Description Sets users settings. Normal-level users can configure only their own settings. 

Admin-level users can configure any users settings, including their own (with the 

exception of their User Level, which must stay at Admin).

User Level Normal, Admin
Syntax

set user .|<username>|*  

[host-ip None|<ip_address>|<config_host>]  
[hotkey-prefix <00-7f>] [idle-timer <0-4294967>]   
[language english|customlang]  
[level admin|normal|restricted|menu] [password]  
[line-access readin|readwrite [on|off]|<line(s)> [0]]  
[service dsprompt|telnet|tcp-clear] [sess-timer <0-4294967>] 
[port tcp-clear|telnet <tcp_port>]

For outbound User Services such as 

, this is the target host name or IP address. If 

no IP address is specified, the 

 value in the 

 configuration will be 

used. The default is 

. or None.

The prefix that a user types to control the current session. The default value is 

, 

which corresponds to 

 (

) (hex value 02 would be Ctrl-b (^b), etc.):

z

—To switch from one session to another, press 

 and then the required 

session number. For example, 

 would switch you to session 2. Pressing 

 

will return you to the IOLAN Menu.

z

—Display the next session. The current session will remain active. The lowest 

numbered active session will be displayed.

z

—Display the previous session. The current session will remain active. The 

highest numbered active session will be displayed.

z

 

—To exit a session and return to the IOLAN. You will be returned to where 

you left off. The session will be left running.

z

—(Lowercase L) Locks the line until the user unlocks it. The user is prompted 

for a password (any password, excluding spaces) and locks the line. Next, the user 

must retype the password to unlock the line.

z

 

—When you switch from a session back to the Menu, the screen may not be 

redrawn correctly. If this happens, use this command to redraw it properly. This is 

always 

, regardless of the 

.

The 

 value overrides the 

 value. You can use the 

 keys to lock a line only when the line 

 parameter is 

.

The amount of time, in seconds, that the 

 will run. Use this timer to close a 

connection because of inactivity. When the 

 expires, because there has been 

no exchange of data within the specified time, the IOLAN will close the connection. 
The default value is 

 (zero), meaning that the 

 will not expire (the 

connection is open permanently). The maximum value is 4294967

 

seconds. The 

 will override the 

, with the exception of reverse Telnet 

sessions.

You can specify whether a user will use 

 or 

 as the language that 

appears in the Menu or CLI. The IOLAN supports one custom language that must be 

downloaded to the IOLAN; otherwise, 

 defaults to English.