Perle Systems 5500208-43 用户手册

 50

Line Service Commands

You can specify how the DTR signal pin acts during your modem application 

connection, as itself (DTR), as DCD, or as RI.

You can specify how the RTS signal pin acts during your modem application 

connection, as itself (RTS), as DCD, or as RI.

One of the following:

z

Verbose—Return codes (strings) are sent to the connected device.

z

Numeric—The following characters can be sent to the connected device:
0 OK
1 CONNECTED
2 RING
3 NO CARRIER
4 ERROR
6 ITERFACE DOWN
7 CONNECTION REFUSED
8 NO LISTNER

String that is sent to the serial device when a connection succeeds. If no string is 

entered, then the string 

 will be sent with the connecting speed, for example 

.

If set to 

, connection success/failure indication strings are sent to the connected 

device, otherwise these indications are suppressed.

Description This command associates a phone number with an IP address and TCP port. This 

enables the existing modem application to issue a dial command with a phone number.  

The phone number will be searched in this table and if an exact match is found, the 

associated IP address and TCP port will be used to establish the connection. This is a 
universal command, meaning that all VModem lines will have access to the entries 

defined here. 1-port models support up to 4 entries, all other desktop models support up 

to 8 entries, and rack-mount models support up to 48 entries.

User Level Admin
Syntax

[<ip_address <number>|host <string>] [port <TCP_port>]

entry
Specify the entry number in the vmodem phone number table.

Specify the phone number that your application uses to connect to remote location.  

Enter the number exactly as it is issued by your application.