Toshiba 510D 用户手册

下载
页码 15
1) If the server is in operation, shut it down, switch 
off the power, and unplug the power cable. 
 
2) Remove memory modules as needed to observe 
the 1,7 MB limit. 
 
3) Install Windows NT Server 4.0 and Windows NT 
4.0 Service Pack with the memory capacity at less 
than 1,7 MB. 
 
4) After installing Windows NT server 4.0, please 
replace memory that is above than 1,7 MB. 
 
For installing and removing the memory modules, 
refer to MAGNIA User’s Guide  
(on the Documentation CD ROM), Chapter 2
 
(3) Installing Windows NT Server 4.0 to the server 
with an MO device.
 
Using an MO device with this server may prevent the 
correct installation of Windows NT Server 4.0. In this 
case, remove the MO device before installing 
Windows NT Server 4.0. As a precaution, replace the 
server’s panels before switching it on. For installing 
and removing the MO device, refer to MAGNIA 
User’s Guide (on the Documentation CD ROM), 
Chapter 2
 
(4)
 Network adapter setup
 
1)Check the connector panel on the Network 
adapter to see if the "530LTX" label is attached. 
 
2)Enter the following settings in Network adapter’s 
propaties when the Network adapter has been 
installed from the floppy disk or when the Network 
adapter properties have been selected on the 
control panel network. 
 
2/15 
S00047-EN  EH02  Rev. E