KVH Industries TracPhone V7 用户手册

15

Follow these steps to connect power to the 
TracPhone V7 system.

a. Before you begin, disconnect vessel power.

b. Be sure the vessel is properly grounded in 

accordance with marine standards. 

c. Connect the control unit and modem to the 

supplied AC power strip (see Figure 31 and 

Figure 32). Use the special adapter cables 

provided in the kitpack.

d. Connect the appropriate power cord (US or 

European) to the power strip. 

e. Connect the supplied AC/DC adapters to the 

MTA, router, and remote service & support 

module. Then plug the adapter cables into 

the vessel’s AC power supply.

f. Strain-relieve all wires at the back of the 

control unit and modem by securing them to 

the attached strain-relief bracket(s). Use the 

tie-wraps supplied in the kitpack. Be sure to 

leave enough slack in the cables for easy 

serviceability. 

g. Plug the power strip into the vessel’s 115 or 

230 VAC power supply.

For your own safety, disconnect vessel power 

and make sure the circuit is dead before you 

connect any power cables. 

Vessel AC Power
(115 or 230 VAC)

Power

Strip 

AC/DC

Adapter

Control Unit

Modem

Remote Service Module

MTA

AC/DC

Adapter

Router

AC/DC

Adapter

AC Input

12 VDC

Power

AC Pwr

Power

Figure 31:  Power Wiring

Figure 32:  Power Strip for Control Unit and Modem

Do not cut off the ground pin from the control 

unit and modem power cable plugs, and do 

not use a 3-prong to 2-prong adapter.

Double-check all of your wiring before 

continuing. If wiring is incomplete or 

incorrect, electronics may become damaged 

when you apply power.

Connect Power

10