Advantek Networks APS-U3100 用户指南

 

Print jobs are sent to the print queue successfully, but fail to be sent to the printer.  

Possible explanations  

1. The Print server Name/Print Queue configuration in PCONSOLE is incorrect.  

2. The Print server name specified and stored in the print server memory doesn’t match the same 

one set in PCONSOLE.  

3. The network cable or power adapter connected to the print server is loose or disconnected.  

4. The printer is off-line, jammed or out of paper.  

 

Solutions  

1. Check all the information in PCONSOLE.  

2. Check all the information of the print server by running PSAdmin.  

3. Check to see that if the network cabling and power adapter are properly connected.  

4. Recheck the print server connection by running the PSAdmin. It should read “Connected.”  

 

Print jobs start printing, but print very slowly or print unknown characters.  

Possible explanation and solution  

A printer driver is missing or is incompatible with that printer. Using a print driver that is not 

specific for the printer can cause printing errors. Install the proper printer driver. If these printer 

drivers are not available to you, please contact your printer manufacturer.  

Question C  

The upgrading process indication bar stops and does not seem to proceed again while upgrading 

the print server.  

Possible Explanation  

There might be a network problem. This causes the upgrading procedure to fail.  

Solutions  

1. Check the network cabling, especially from the workstation running the PSAdmin to the print 

server unit.