Bosch Appliances Security Camera PT-400 用户手册

Security Escort | Technical Reference Manual | 3.0  System Menus 
and Screens 

EN | 57 

 

 

Bosch Security Systems | 6/12 | 38947D 

 

Alarm Spot Size 
This setting changes the size of the 
yellow dot that marks the calculated 
location of the alarm. The settings 
range from 19 to 76 (half to double the 
default alarm dot size). It is best to 
set the size of the alarm spot so it 
represents a diameter of 15.24 m (50 
ft.) on the displayed map (this is the 
area where the transmission of the 
alarm most likely took place). The 
Enable Algorithm Tweaks checkbox must 
be checked for this to be displayed. 
Linear Depth 
This setting controls the involvement 
of receivers in the alarm location 
calculation only when the Linear 
Algorithm is being used. The setting 
can range from zero to six (it defaults 
to two). When set to zero, only the 
receivers closer to the actual location 
of the alarm are considered in the 
location calculation. As the setting is 
raised, more distant receivers are 
included in the alarm calculation. 
Typically, lower settings are better 
than higher settings. Change this 
setting if there are known problems 
with the location using the Linear 
Algorithm. The Enable Algorithm Tweaks 
checkbox must be checked for this to 
display. 
Low Depth  
This setting controls the involvement 
of receivers in the alarm location 
calculation only when the Low Algorithm 
is being used. The setting can range 
from zero to six (it defaults to two). 
When set to zero only, the receivers 
that are closer to the actual location 
of the alarm are considered in the 
location calculation. As the setting is 
raised, more distant receivers are 
included in the alarm calculation. 
Typically, lower settings are better 
than higher settings. Change this 
setting if there are known problems 
with the location using the Low 
Algorithm. The Enable Algorithm Tweaks 
checkbox must be checked for this to 
display. 

Medium Depth  
This setting controls the involvement 
of receivers in the alarm location 
calculation only when the Medium 
Algorithm is being used. The setting 
can range from zero to six (it defaults 
to two). When set to zero only, the 
receivers that are closer to the actual 
location of the alarm considered in the 
location calculation. As the setting is 
raised, more distant receivers are 
included in the alarm calculation. 
Typically, lower settings are better 
than higher settings. Change this 
setting if there are known problems 
with the location using the Medium 
Algorithm. The Enable Algorithm Tweaks 
checkbox must be checked for this to 
display. 
Strong Depth  
This setting controls the involvement 
of receivers in the alarm location 
calculation only when the Strong 
Algorithm is being used. The setting 
can range from zero to six (it defaults 
to two). When set to zero only. the 
receivers that are closer to the actual 
location of the alarm are considered in 
the location calculation. As the 
setting is raised, more distant 
receivers are included in the alarm 
calculation. Typically, lower settings 
are better than higher settings. Change 
this setting if there are known 
problems with the location using the 
Strong Algorithm. The Enable Algorithm 
Tweaks checkbox must be checked for 
this to display. 
3.3.18 Transponder Comm Port Setup 

This screen connects the Comm port 
indexes set for each transponder in the 
Transponder Database to the physical 
Comm ports on the computer.