Wybron pmn 用户手册
6
Power Supply
The Power Supply converts the DMX512 signal level from the lighting
console into Coloram I / Coloram II control signal which it then sends to
each Color Changer along with 24 volts DC. The Power Supply
features a DMX bypass relay to pass the DMX signal to the DMX output
connector in the event of AC power loss.
console into Coloram I / Coloram II control signal which it then sends to
each Color Changer along with 24 volts DC. The Power Supply
features a DMX bypass relay to pass the DMX signal to the DMX output
connector in the event of AC power loss.
The Power Supply features an 8 character LED display and three
selector buttons. This user interface is used to select the starting DMX
channel, set operating modes, send remote commands to the Color
Changers and view Color Changer status.
selector buttons. This user interface is used to select the starting DMX
channel, set operating modes, send remote commands to the Color
Changers and view Color Changer status.
Coloram Cables
The Coloram cable connects the Coloram Power Supply outputs to the
Coloram Color Changers or other products and provides them with
power and control signal. The Coloram cable uses 4-pin XLR
connectors on either end and consists of two 14 AWG conductors and
a 22 AWG twisted, shielded pair.
Coloram Color Changers or other products and provides them with
power and control signal. The Coloram cable uses 4-pin XLR
connectors on either end and consists of two 14 AWG conductors and
a 22 AWG twisted, shielded pair.
Note: The cable used in the Coloram System is the same cable which is
used in the Forerunner System and may be referred to as either
Coloram cable or Forerunner cable.
used in the Forerunner System and may be referred to as either
Coloram cable or Forerunner cable.