Whirlpool GXU7130DXS 业主指南

1. Install vent through the vent opening in upper cabinet or wall. 

Complete venting system according to the selected venting 
method. See “Venting Requirements” section. 

2. Use caulking to seal exterior wall or roof opening around the 

cap.

1. Remove the grease filters. See the “Range Hood Care” 

section.

■

Depending on your installation, remove either top or rear 
rectangular vent knockout. If using round vent, remove 
top rectangular knockout.

■

Make sure damper pivot is nearest to top/back edge of 
range hood. 

■

Remove tape from damper flap.

NOTE: The exhaust adaptor/damper can be installed up 
to 1" (2.5 cm) on either side of the hood center to 
accommodate off-center ductwork.

■

If using rectangular vent, attach rectangular damper/vent 
connectors to the range hood using sheet metal screws.

NOTE: If the wall cap is directly behind the vent 
connector, the dampers in the connector and wall cap 
must not interfere with each other. Remove the vent 
connector damper if they interfere.

■

If using round vent, attach vent transition piece 
(purchased separately) to range hood top using sheet 
metal screws.

2. Lift the range hood up under cabinet and determine final 

location by centering beneath cabinet. Mark on the underside 
of cabinet the location of the 4 keyhole mounting slots on the 
range hood. Set range hood aside on a covered surface.

3. Use 

¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown.

4. Install the 4 - 4.5 mm x 13 mm mounting screws in pilot 

holes. Leave about 

¹⁄₄" (6.4 cm) space between screw heads 

and cabinet to slide range hood into place.

5. Run the home power supply cable according to the National 

Electric Code or CSA standards and local codes and 
ordinances. There must be enough wiring from the fused 
disconnect (or circuit breaker) box to make the connection in 
the hood electrical terminal box.

NOTE: Do not reconnect power until the installation is 
complete.

6. Remove the screws from the terminal box cover. Then slide 

the cover toward the outside edge of range hood to position 
the large end of the keyhole slots over the mounting tabs.

B

A

B

C

D

C

E

A

A

A

B

C