Stihl FS 45 说明手册
20
English / USA
FS 45, FS 46
STIHL Polycut 6-3
:
Fit the thrust plate on the shaft.
:
Insert mounting nut (10) in the
mowing head.
mowing head.
:
Screw mowing head (11) clockwise
onto the shaft (5) as far as stop.
onto the shaft (5) as far as stop.
:
Block the output shaft with the stop
pin.
pin.
:
Tighten down the mowing head.
Remove the tool used to block the
shaft.
Remove the tool used to block the
shaft.
Blocking the shaft
:
Block the shaft by pushing the stop
pin (12) through the holes (13) in the
deflector and thrust plate – turn the
thrust plate back and forth if
necessary.
pin (12) through the holes (13) in the
deflector and thrust plate – turn the
thrust plate back and forth if
necessary.
:
Tighten down the mowing head
firmly.
Remove the tool used to block the
shaft.
firmly.
Remove the tool used to block the
shaft.
STIHL FixCut 5-2
:
Fit the thrust plate (2) on the shaft.
:
Place the mowing head on the
thrust plate (2).
Collar (arrow) must locate in the
mowing head’s mounting hole.
thrust plate (2).
Collar (arrow) must locate in the
mowing head’s mounting hole.
:
Push the thrust washer (3) over the
shaft (1) so that it locates against
the base.
shaft (1) so that it locates against
the base.
:
Block the output shaft.
:
Use the combination wrench (5) to
screw the mounting nut (4)
counterclockwise onto the output
shaft and it tighten down firmly.
Remove the tool used to block the
shaft.
screw the mounting nut (4)
counterclockwise onto the output
shaft and it tighten down firmly.
Remove the tool used to block the
shaft.
11
5
681BA019 KN
10
3
1
2
4
232BA074 KN
5