RuggedCom RuggedRouter RX1000 用户手册
Chapter 20 – Configuring GOOSE Tunnels
General Configuration Menu
Figure 165: General Configuration Menu
This menu configures the daemon settings.
The Daemon UDP Listen Port field configures port used by the daemon to
communicate with other daemons.
The Daemon UDP Listen Port field configures port used by the daemon to
communicate with other daemons.
Note: All Layer 2 Tunnel daemons in the network must use the same port number.
If the router employs a firewall, ensure that a hole is opened for each of the remote
daemons using on this port number.
The Beacon Interval field configures how often a Round Trip Time (RTT)
measurement message is sent to each remote peer. The interval takes the values
“Off” to disable RTT measurement or a time of 10 – 3600 seconds.
measurement message is sent to each remote peer. The interval takes the values
“Off” to disable RTT measurement or a time of 10 – 3600 seconds.
GOOSE Tunnels Menu
Figure 166: GOOSE Menu
This menu displays GOOSE tunnels. Configure an existing tunnel by following the
link under the Ethernet Interface field, or add a new tunnel.
link under the Ethernet Interface field, or add a new tunnel.
Figure 167: GOOSE Menu
This menu configures a GOOSE tunnel.
The Ethernet Interface field configures suitable (i.e. VLAN eligible) interfaces to
listen for GOOSE frames upon. You may set this field to “none” if the intent is
simply to relay network packets.
The Ethernet Interface field configures suitable (i.e. VLAN eligible) interfaces to
listen for GOOSE frames upon. You may set this field to “none” if the intent is
simply to relay network packets.
RuggedCom 197