Frigidaire FFEF3009PW 业主指南
13
Replacing the oven light (some models)
Be sure the range is unplugged and all parts are COOL before
replacing oven light. Wear a leather-faced glove for protection
against possible broken glass.
CAUTION
The interior oven light bulb is located at the upper left rear
of the oven cavity.
To replace the oven light bulb
To raise the cooktop for cleaning (some models)
1. Grasp the sides and lift from the front (See Fig. 1). Lift-up
rods will support the top in a raised position. Only lift the
cook top far enough to allow the support rods to snap into
place.
2. Clean underneath using a clean cloth and hot, soapy
water.
3. To lower, hold the cooktop up and gently push back on
each rod to release the notched support. Hold the cooktop
while slowly sliding the lift rods down into the range
frame.
CAUTION
Fig. 1
• When lowering the lift-up range cooktop, grasp the
sides with finger-tips only. Be careful not to pinch
fingers. DO NOT drop or bend the range cooktop when
raising or lowering. This could damage the cooktop
surface.
CARE & CLEANING
For models that have a visible lower bake element
ONLY - This bake element was designed to be tilted up
using your hand from the front of the bake element for
cleaning purposes. Remove the bottom oven rack before
raising the element. Do not to raise the element more than
4 or 5 inches from the resting position.
Cleaning under lower element (some models)
CAUTION
The oven bake and broil elements may appear to have
cooled after they have been turned OFF. The elements
may still be hot and burns may occur if these elements
are touched before they have cooled sufficiently.
Cleaning under cooktop (some models)
1. Turn electrical power off at
the main source or unplug
the range.
2. Replace bulb with a new 40
watt appliance bulb.
3. Turn power back on again at
the main source or plug the
appliance back in.
4. The clock will need to be
reset (some models). To
reset, see “Setting the clock”
in this Use & Care Guide.
oven
light
cooktop
support rods