GE JNM3163DJBB 安装指导

 

     

 

C1. Attach Mounting Plate to Wall
C2. Prepare Top Cabinet 
C3. Adjust Blower
C4. Mount the Oven
C5. Install Charcoal Filter

 Read the instructions on the TOP CABINET 

TEMPLATE.

 Tape it underneath the top cabinet.

 Drill the holes, following the instructions on the TOP 

CABINET TEMPLATE.

 Wear safety goggles when 

drilling holes in the cabinet bottom.

You need to drill holes for the top support screws and a 

hole large enough for the power cord to fit through.

  Place the mounting plate against the wall and insert 

the toggle wings into the holes in the wall to  

mount the plate.

NOTE: Before tightening toggle bolts and wood screw, 

make sure the tabs on the mounting plate touch the 

bottom of the cabinet when pushed flush against the 

wall and that the plate is properly centered under the 

cabinet.

 Be careful to avoid pinching 

fingers between the back of the mounting plate and 

the wall.
  Tighten all bolts. Pull the plate away from the wall to 

help tighten the bolts.

Attach the plate to the wall using toggle bolts. At least 

one wood screw must be used to attach the plate to a 

wall stud.
  Remove the toggle wings from the bolts. 
  Insert the bolts into the mounting plate through the 

holes designated to go into drywall and reattach 

the toggle wings to 

3

/

4

”

 onto each bolt. 

Wall

Mounting 

Plate

Spacing for 

Toggles More Than 

Wall Thickness

Bolt End

Toggle  

Bolt

Toggle Wings