GE JNM3163DJBB 安装指导

  Find the studs, using one of the following  

methods:

 

A.  Stud finder – a magnetic device which  

locates nails.

 

B.  Use a hammer to tap lightly across the  

mounting surface to find a solid sound.  

This will indicate a stud location.

  After locating the stud(s), find the center by  

probing the wall with a small nail to find the  

edges of the stud. Then place a mark halfway between 

the edges. The center of any adjacent  

studs should be 16

” 

or 24

”

 from this mark.

  Draw a line down the center of the studs.
THE OVEN MUST BE CONNECTED TO AT LEAST ONE 

  Remove the turntable, installation instructions, 

filters, exhaust adaptor, damper, shelf and the small 

hardware bag. Do not remove the foam packing 

protecting the front of the oven.

  Fold back all 4 carton flaps fully against carton sides. 

Then carefully roll the oven and carton over onto 

the top side. The oven should be resting in the foam 

packing.

        

Wall  

Studs

Center

Carton

  Pull the carton up and off the oven. 

   Open the oven door and remove any packing 

material, if present, from inside the oven.

Foam packing

  Set the oven upright. Remove and properly discard 

plastic bags and foam packing.

  The mounting plate is attached to the back of the 

oven. Remove the two screws holding it to the oven.  

The plate will be used as the rear wall template and 

for mounting the oven to the wall.