Liebherr HRB1120 安装指导
Fig. 17
u
Check all screws and retighten if necessary.
u
Fit the bottom left cover again. Only fit the other covers
again after installing the appliance into the cabinet
again.
10 Water connection*
WARNING
Electrical Shock Hazard!
u
Do not make the water connection while the appliance
is connected to an electrical outlet.
u
Disconnect the water supply before connecting the
water lines for the IceMaker.
u
The connection to the water supply may only be made
by a trained and licensed plumber.
WARNING
Poisoning Hazard!
u
The water quality must comply with the drinking water
regulations for the geographical area where the appli-
ance is located.
u
Connect to potable water supply only.
u
The IceMaker is designed exclusively to make ice
cubes in quantities needed by a household and must
only be operated with water appropriate for this
purpose.
Water pressure:
psi
psi
MPa (bars)
21.76 to 87.02 0.15 to 0.6 (1.5 to 6)
If a water filter is used, the instructions on water pressure
in the Installing the water filter section apply.
- Water must be supplied to the appliance through a cold
- Water must be supplied to the appliance through a cold
water pipe that complies with hygiene standards and
can withstand the operating pressure.
- All devices and equipment used to supply water must
comply with the regulations in force in the respective
country.
- The solenoid valve is located at the bottom of the back
of the appliance. It has a metric R3/4 connecting
thread.
- Use a 1/4"-OD copper wire to connect the water
supply with the solenoid valve. This is not supplied
with the appliance.
- If your model has an IceMaker, a coupler is supplied
between the metric R3/4 connection thread and the
1/4"-OD copper wire.
Fig. 18
u
Remove the cap
Fig. 18 (1)
from the solenoid valve
Fig. 18 (2)
.
u
Insert the coupler
Fig. 18 (3)
into the union nut
Fig. 18 (4)
.
u
Insert the water filter
Fig. 18 (5)
with the recess pointing
down towards the coupler
Fig. 18 (3)
.
NOTICE
Risk of damage to the water filter!
If you insert the filter incorrectly you could damage it.
u
Insert the filter with the recess pointing towards the
coupler.
u
Lock the union nut
Fig. 18 (4)
onto the solenoid valve
Fig. 18 (2)
and tighten.
NOTICE
Risk of damage to the thread!
u
Do not overtighten the union nut.
u
Connect the water supply
Fig. 18 (6)
(e.g.copper) to the
coupler
Fig. 18 (3)
by using the clamping ring
Fig. 18 (7)
and nut
Fig. 18 (8)
.
Water connection
* Depending on model and options
11