KitchenAid KUWL304ESS-SS 用户手册

INSTALLATION REQUIREMENTS

Tools

Gather the required tool before starting installation. 

■

Phillips screwdriver

Location Requirements

NOTES: 

■

For the wine cellar to be flush with the front of the base 
cabinets, remove any baseboards or moldings from the rear 
of the opening. See “Opening Dimensions” later in this 
section.

■

It is recommended that you do not install the wine cellar near 
an oven, radiator, or other heat source. 

■

Do not install in a location where the temperature will fall 
below 55°F (13°C). For best performance, do not install the 
wine cellar behind a cabinet door or block the base grille. 

■

Height dimensions are shown with the leveling legs extended 
to the minimum height.
NOTE: When leveling legs are fully extended, add 

⁵⁄₈" (15 mm) 

to the height dimensions.

■

If the floor of the opening is not level with the kitchen floor, 
shim the opening to make it level with the kitchen floor.

Electrical Requirements

Before you move your wine cellar into its final location, it is 
important to make sure you have the proper electrical 
connection.

A 115 volt, 60 Hz., AC only, 15- or 20-amp fused, grounded 
electrical supply is required. It is recommended that a separate 
circuit serving only your wine cellar be provided. Use an outlet 
that cannot be turned off by a switch. Do not use an 

 

extension cord.

NOTE: Before performing any type of installation, cleaning, or 
removing a light bulb, unplug wine cellar or disconnect power.

³⁄₄

A

B