KitchenAid KMBS104ESSSS 安装指导
2
INSTALLATION REQUIREMENTS
Tools and Parts
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Read and follow the instructions provided with any tools
listed here.
Parts Supplied
All of the following parts are provided, but not all parts will be
used. The cutout opening size will determine which parts you will
use. See chart below parts list to see which parts are used for
each installation.
used. The cutout opening size will determine which parts you will
use. See chart below parts list to see which parts are used for
each installation.
Location Requirements
The microwave oven may be located in a cabinet, and/or above a
built-in oven, or below the counter and/or below a non-vented
cooktop. Check the opening where the microwave oven will be
installed. The location must provide:
built-in oven, or below the counter and/or below a non-vented
cooktop. Check the opening where the microwave oven will be
installed. The location must provide:
■
Wood cabinetry.
■
Cutout opening that is plumb and square. See “Minimum
Cutout Dimensions” in “Minimum Dimensions” section.
Cutout Dimensions” in “Minimum Dimensions” section.
■
Cutout floor that is solid, level and flush with bottom of
cabinet cutout.
cabinet cutout.
■
Support for weight of at least 150 lbs (68 kg), which includes
microwave oven and items placed inside.
microwave oven and items placed inside.
■
Grounded electrical outlet. See “Electrical Requirements”
section.
section.
■
Minimum installation clearances for installation location. See
“Minimum Dimensions” section.
“Minimum Dimensions” section.
■
Complete enclosure around the recessed portion of the
microwave oven.
microwave oven.
■
Measuring tape
■
Pencil
■
T10 TORX
®†
screwdriver
■
Drill
■
5/64" (2 mm) drill bit
A. Side brackets (2)
B. Extension plates (2)
B. Extension plates (2)
C. 3/8" T10 screws (4)
D. 1" T10 screws (6)
D. 1" T10 screws (6)
E. Narrow side trim panels (2)
F. Wide side trim panels (2)
INSTALLATION
PARTS USED
24" (61.0 cm) installation
D
27" (68.6 cm) installation
A, D, E
30" (76.2 cm) installation
A, B, C, D, F
†®TORX is a registered trademark of Acument Intellectual Properties, LLC.
A
B
C
D
F
E