KitchenAid KUDS30FXPA 安装指导

下载
页码 56
15
NOTE: If the minimum cabinet opening height is less than 34" 
(86.4 cm), the rear wheels can be removed for additional 
clearance. This will allow the dishwasher to fit into a 33
⁷⁄₈" (86 cm) 
high cabinet opening, but the dishwasher will be more difficult to 
move. (Measurements are approximate. Wheels and legs are 
preset at the factory for 34
¹⁄₂" [87.6 cm]). If the minimum cabinet 
opening height is 33
³⁄₄" (85.7 cm), a section in the insulation 
blanket can be removed by cutting along the perforation.
Turn both leveler legs to the same height. Put wheels in the 
required position determined from “Dishwasher Height 
Adjustment Chart.”
Built-up floors: If the kitchen floor is higher than the cabinet 
opening's floor - for example, the kitchen floor tile does not 
extend into the cabinet opening - add shims as needed in the area 
shown to bring the dishwasher up to 34" (86.4 cm) below the 
countertop.
NOTE: Shims must be securely attached to floor to avoid 
movement when the dishwasher is in use.
Install Door Handle
(on some models)
IMPORTANT: Do not scratch the front panel during this 
procedure.
Remove the door handle and hardware bag containing the 
setscrews and hex key from the cardboard box. Setscrews are 
already installed in the handle. Place handle on mounting studs 
with the setscrews facing down. Push the door handle tightly 
against the door. Insert the short end of the hex key into the 
setscrews. Tighten the setscrews 
¹⁄₄ turn past snug.
Retain hex key with Installation Instructions.
Custom Panel Dimensions