KitchenAid KFGS530ESS-SS 用户指南

Oven Light

The oven light is a standard 40-watt appliance bulb. Before 
replacing, make sure the oven and cooktop are cool and the 
control knobs are in the Off position.

1. Unplug range or disconnect power.

2. Turn the glass bulb cover in the back of the oven 

counterclockwise to remove.

3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb by turning clockwise.
5. Replace bulb cover by turning clockwise.
6. Plug in range or reconnect power.

PROBLEM SOLVER

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer 
to the warranty page in this manual and scan the code there with your mobile device, or visit http://kitchenaid.custhelp.com. In Canada, 
visit http://www.kitchenaid.ca.

Contact us by mail with any questions or concerns at the address below:

In the U.S.A.:

KitchenAid Brand Home Appliances

 

Customer eXperience Center

 

553 Benson Road

 

Benton Harbor, MI 49022-2692

In Canada:

KitchenAid Brand Home Appliances

 

Customer eXperience Centre

 

200 - 6750 Century Ave.

 

Mississauga, Ontario L5N 0B7

Please include a daytime phone number in your correspondence.

Power supply cord is unplugged - Plug into a grounded 3 prong outlet.
Energy Save is active, and the display is blank - Press any keypad on the control to display the time 
of day. See the “Electronic Oven Controls” section for more information.
Household fuse is blown or a circuit breaker is tripped - Replace the fuse or reset the circuit breaker. 
If the problem continues, call an electrician.
Main or regulator gas shutoff valve is in the off position - See the Installation Instructions.
The range is improperly connected to the gas supply - Contact a trained repair specialist or see the 
Installation Instructions.

The control knob is not set correctly - Push in knob before turning to a setting.
Air in the gas lines - If this is the first time the surface burners have been used, turn on any one of the 
surface burner knobs to release air from the gas lines.
Clogged burner ports - See the “Sealed Surface Burners” section.

Clogged burner ports - See “Sealed Surface Burners” section.
Burner caps positioned improperly - See “Sealed Surface Burners” section.
Range converted improperly - If propane gas is being used, contact a service technician or see the 
“Warranty” section for contact information.

Cookware and flame are not matched - The cookware should be centered above the burner with the 
bottom sitting level on the grate. The flame should be adjusted so that it does not extend up the sides of 
the pan.