Fujitsu C120-E361-04EN 用户手册

C120-E361-04EN

1-3

1.2  RCI command

RCI commands are used to display RCI configuration information and set node 

addresses.

To connect I/O units equipped with RCI ports, a setup using RCI commands is 

required in addition to the connection with RCI cables.

Remarks:  When you use the terminal function of the External power controller, 

perform the setrcic command and confirm setting or connection of the 

External power controller.  For details of the setrcic command, see the RCI 

User's Guide or man page.

The RCI commands are explained below.

Table 1.1  Command list

Command

Function

setrci -c stat

Displays RCI configuration information.  This command 

is used after the RCI setup to verify 

that the settings of the host and I/O units have been made 

correctly.

setrci -c init

Initializes the RCI configuration information.

If other host units are connected through the RCI, the 

RCI settings must be initialized on each host unit.

You can use this command if the system is powered off.

setrci -c set [host_no] Sets up an RCI Host node.

Before this command can be executed, the RCI settings 

must already have been initialized.

  host_noÅF Integer numbers from 1 to 32 are assigned 

in this order.

setrci -c initconfig

Assigns an RCI address to an I/O unit connected via RCI.

Before this command can be executed, the RCI Host 

node settings must already have been made.

setrci -c addconfig

Makes the RCI settings for the case that a host unit or an 

I/O unit is added.