Mitsubishi Electronics FX1S 用户手册

FX1S Series Programmable Controllers

4-1

The wiring of FX

1S

 products has been designed to be safe and easy. If during the installation of

these product or associated products concern is felt, please contact a professional electrician
who is trained to the local and national standards applicable to the installation site.

• Do not run input signals in the same multicore cable as output signals or allow them to

share the same wire.

• Do not lay I/O signal cables next to power cables or allow them to share the same trunking

duct. Low voltage cables should be reliably separated or insulated with regard to high volt-
age cabling.

•

Where I/O signal lines are used over an extended distance consideration for voltage drop
and noise interference should be made.

When wiring AC supplies the “Live” cable should be connected to the “L” terminal and the
“Neutral” cable should be connected to the “N” terminal.  Do NOT connect the “Live” wire to the
“N” terminal, the user might receive a dangerous shock on powerup.