Ingersoll-Rand 45541935 产品宣传页

    45546181

Edition 1 

June 2007

www.irtools.com

© 2007 Ingersoll Rand Company

This product is designed to be mounted on an lngersoll Rand B006 Barring Motor. It prevents voltage from being applied to an engine starting 

system while the Barring Motor is engaged with the Ring Gear of the Engine.

Manuals can be downloaded from www.irtools.com.

Switch: Normally closed

Maximum voltage: 250 Volts

Maximum current: 10.1 Amps

Connectors: .110 inch solder lug male terminals (2)

When the Barring Motor is disengaged from the Engine Ring Gear, the switch is closed, and voltage can reach the solenoid to start the Engine. 

When the Barring Motor is engaged with the Engine Ring Gear, the switch is open, and voltage cannot reach the solenoid to start the Engine.

1.   Remove two of the three 1/4-inch Socket Head Cap screws from Air Motor Assembly. Insert the screws through the Bracket (1) into the  

Air Motor  Assembly and torque to 4.5/5.0 ft.lbs.

2.   Remove two of the six 5 mm Socket Head Cap screws that hold the Ring to the Barring Motor Housing. Insert the screws through the holes 

in the Plate (2), into the holes in the Housing, and apply Loctite #243 - torque to 4.5/5.2 ft.lbs.

3.   Connect the wire from the voltage supply to a terminal on the Limit Switch (5).

4.   Connect the wire from the starter to the other terminal on the Limit Switch (5).

5.   Place the Limit Switch (5) on top of the Bracket (1). Insert the two #2 Socket Head Cap screws (4) through the holes in the Cover (3), through 

the holes in the Limit Switch (5), into the holes in the Bracket (1), and tighten.

4

5

1

3

2

5 mm Socket Head Cap Screw

1/4" Socket Head Cap Screw

(Dwg. 45540911)

1

45540754

Bracket

1

2

45540713

Plate

1

3

45540671

Cover

1

4

45540663

Cap Screw

2

5

45540648

Limit Switch

1

6

45546181

Installation Sheet

1