GE ZSC1202SS 用户手册

Design Information
Models Available......................................................................2
Product Dimensions and Clearances ............................3
Tools and Parts Required ....................................................3
Parts Supplied ..........................................................................3
Electrical Tools and Parts Required ................................3
Advance Planning ..................................................................3

Installation Preparation
Electrical Requirements........................................................4
Install Junction Box ................................................................4
Preparing the Opening (Installation without

Installation Instructions
Step 1, Remove Packaging and Parts ........................13
Step 2, Install Door Trim ....................................................14
Step 3, Route Conduit ........................................................14
Step 4, Install Bottom Trim ..............................................15
Step 5, Install Mounting Screws ....................................15
Step 6, Finalize Installation ..............................................15

Save these instructions 

for local inspector’s use. 

Observe all governing codes

and ordinances.

Be sure to leave these

instructions with the Consumer.

Keep these instructions 

with your Owner’s Manual for future reference.

Installation of this appliance

requires basic mechanical and electrical skills.

• Proper installation is the responsibility 

of the installer. Product failure due to improper
installation is not covered under the warranty.
See Owner’s Manual for warranty information.

NOTE: This oven is only approved to be installed
under the specific models as labeled on this unit.

Use this oven only 

for its intended purpose. Never use the oven 
for warming or heating a room. Prolonged use 
of the oven without proper ventilation can 
be hazardous.

For personal safety, remove house fuse or oven
circuit breaker before beginning installation 
to avoid severe or fatal shock injury.

For personal safety, the mounting surface 
must be capable of supporting the cabinet load, 
in addition to the added weight of the 80-pound
oven and 30-pound drawer, plus additional oven
loads of up to 50 pounds or a total weight of up 
to 160 pounds.

If installing the Advantium 120V Oven below 36

″,

you must use the plastic bottom trim due to burn
risk to children. The plastic trim acts as insulation
and will help prevent burns to children from hot
surfaces.

If installing the Advantium 120V Oven below 36

″,

do not remove the plastic door trim due to burn
risk to children. The plastic trim acts as insulation
and will help prevent burns to children from hot
surfaces.

Profile Models:
PSB1200WW–White*
PSB1200BB–Black
PSB1201SS–Stainless Steel

Monogram Models:
ZSC1201SS–Stainless Steel 
ZSC1202SS–Stainless Steel**