Sub-Zero E SERIES 用户手册

下载
页码 8
wolfappliance.com   
|
   3
E SERIES OVEN FEATURES
E Series Oven Features
FEATURE
PG
1
Product Rating Plate
2
2
Adjustable Oven Racks
3
3
Control Panel and Display
4
4
Convection Fans
5
5
Temperature Probe Receptacle
5
6
Halogen Lighting
6
Getting Started
We know you are eager to start cooking, but before you 
do, please take some time to read this use & care guide. 
Whether you are an occasional cook or an expert chef, it 
will be to your benefit to familiarize yourself with the safety 
practices, features, operation and care recommendations of 
your E series oven.
    Clean the oven thoroughly with hot water and mild 
detergent. Rinse and dry with a soft cloth to remove 
any residual oil and grease left from the manufacturing 
process. Refer to care recommendations on page 6.
    To ensure the best results, review cooking modes and 
special features on page 5.
 CAUTION
Do not place cookware on oven floor or use aluminum 
foil or other material to line oven floor or side walls. 
Failure to adhere to this notice will damage the porce-
lain interior and will void your warranty.
0
9
8
7
6
5
4
3
2
1
 
E series single oven.
3
1
6
5
2
4
Oven Racks
OVEN RACK GUIDES
To insert rack guides in the oven, locate mounting screws 
on oven side walls. Place rack guide mounting tabs over 
the screws and slide down until fully seated. Refer to the 
illustration below. 
OVEN RACKS
To insert a standard rack in the oven, place the rack anti-tip 
lock under side rack guide rails. Slide rack back and lift up 
to clear rack stops. Continue to slide rack back until com-
pletely inside the oven. Refer to the illustration below.
OVEN OPERATION
MOUNTING
TAB
MOUNTING
SCREW
ANTI-TIP
LOCK
RACK STOP
 
Oven rack guides.
 
Oven rack anti-tip lock.
The bottom oven rack has a full-extension capability which 
is supported by the oven door. With the rack in the lowest 
rack guide position, slide it onto door guides for greater 
stability and accessibility. Refer to the illustration below.
To insert a full-extension easy glide rack, place the two rear 
tabs onto the rack guide (one tab above and one below). 
Refer to the illustration below. Angle rack slightly and slide 
back until the front rack notch engages the front rack guide.
REAR TABS
NOTCH
 
Bottom rack.
 
Full-extension rack.