Keurig K45 业主指南

A. PREPARE  

Step 1:  To begin, you will need the following: 

At least 48 oz. of undiluted white vinegar  

Access to an empty sink 

A large ceramic mug (do not use a paper cup) 

Step 2:  Empty the water from the Water Reservoir. NOTE: If you are using a 

water filter inside the Water Reservoir, remove it before proceeding.

Step 3:  Disable Auto Off feature.
B. FILL AND CLEAN  

Step 1:   Pour approximately 48 oz. of the vinegar into the Water Reservoir.  

Fill to and not beyond the MAX FILL line.

Step 2:  Place a large mug on the Drip Tray Plate and run a cleansing brew. 

DO NOT USE A K-CUP

®

 PACK

, just press a Brew Button. Pour the 

contents of the large mug into the sink.

Step 3:  Repeat the brew process without a K-Cup

®

 pack until the blue Add 

Water Light illuminates. 

Step 4:  Now let the brewer stand for at least 4 hours while still on.
Step 5:  Discard any residual vinegar and rinse the Water Reservoir thoroughly.
C. RINSE  

Step 1:  Ensure the Water Reservoir is filled with fresh water. Fill to and not 

beyond the MAX FILL line.

Step 2:  Place a large mug on the Drip Tray Plate and run a cleansing brew. 

Pour the contents of the large mug into the sink.

Step 3:  Repeat brew process until the blue Add Water Light is illuminated.
Step 4:  You may need to perform additional cleansing brews if you notice any 

residual taste.

NOTE: If the red Descale Light is still illuminated after completing  

the procedure, repeat the de-scaling procedure above.

Beyond these recommended cleaning and maintenance procedures, this 

brewer is not user serviceable. For service, please refer to the Warranty 

section of this guide.

Empty the Water Reservoir before storing and take care to ensure that you 

store your brewer in a safe and frost free environment. Please be sure to 

store your brewer in its upright position to avoid water leakage from the inner 

tank. If you store the brewer in a cold environment, you run the risk of water 

freezing inside the brewer and causing damage. When you prepare to use it 

after storage, we recommend rinsing the Water Reservoir with fresh water 

and running three cleansing brews without a K-Cup

®

 pack.

If you plan to move your brewer to a different location, turn the brewer off, 

unplug it and empty the Water Reservoir. If your brewer has been in  

an environment below freezing, please be sure to let it warm to room 

temperature for at least 2 hours before using.

SECTION 3 Cleaning & Maintenance

12