Keurig K45 业主指南

SECTION 1 

 

Set-Up & First Brew

 1. 

Unwrap cord and plug the brewer into a 
grounded outlet. Remove all pieces of  

packing tape.

 2.

  Place a large mug (10 oz. minimum) on  

the Drip Tray Plate.

 3.

  Remove the Water Reservoir from brewer by 

first removing Lid from Reservoir (fig. 1), then 
lifting Reservoir straight up and away from 
brewer (may be tight). Rinse with fresh water.

 4. 

Fill Water Reservoir with bottled or filtered  

water so that the water is to and not beyond 
the MAX FILL line.

IMPorTanT: 

You cannot use your Keurig

®

 brewer until 

it has been set-up for its first use as set forth below.

If brewer has been exposed to temperatures 

below freezing, allow brewer at least two hours to 

reach room temperature before brewing. A frozen  

or extremely cold brewer will not operate.

 5.

  Place Water Reservoir base into the left side of 

the brewer and be sure the Water Reservoir 
Lock Tabs engage with the brewer (fig. 2). 
Replace Lid on Water Reservoir.

 6.

  Press Power Button found on upper right 

panel of the brewer. The green Power Light 
will illuminate. NOTE: A K-Cup

®

 pack should 

not be used for this sequence

.

  NOTE: If the Water Reservoir is empty or  

not in place on the brewer, the blue Add Water 
Light will illuminate. The Small Mug Button will 
not be activated until water is added to the  
Water Reservoir.

 7.

  The brewer will automatically fill with water and 

then the water will be heated. This will take 
about 4 minutes. During the heating period, the 
red Heating Light will illuminate. Once the 
water is heated, the red Heating Light will turn 

off and the Small Cup, Small Mug and Large 
Mug Buttons will illuminate. NOTE: Do not lift 

Handle during this heating period.

6

Lock Tabs