Toshiba B-852-R 用户手册
3. PERIODIC MAINTENANCE PROCEDURE
EO18-33018
3. PERIODIC MAINTENANCE PROCEDURE
3-3
5. Apply FLOIL G-488 to the cutter unit using a soft cloth.
6. Clean the Cutter Blade with a cotton swab moistened with absolute ethyl alcohol.
7. Confirm that the problem occurs as reported, and then take corrective action.
8. Replace the following parts periodically, if necessary. The following table shows approximate
product life for each part.
No.
Part Name
Part No.
Standard interval of
replacement
1
Cutter unit (Option)
G0-00415000
1,000,000 cuts
2 Platen
FMCC0054701 50
km
NOTES: 1. The above values of the cutter life are obtained on condition that the periodically
maintained cutter is used with TOSHIBA TEC-approved supplies by the proper
method described in the manuals.
method described in the manuals.
2. The above values differ depending on the thickness and substances of the media to
be used. When using the cutter to cut the labels, be sure to cut the backing paper.
Failure to do this may cause the glue to stick to the cutter and shorten the cutter life.
Failure to do this may cause the glue to stick to the cutter and shorten the cutter life.
8. Confirm each part adjustment. Make any necessary adjustments.
9. Conduct the following tests and make sure that there is no problem.
1) Print test with TOSHIBA TEC-approved media and ribbon. (Print tone, print head position,
etc.)
2) Paper
skew
3) Print start position adjustment (Horizontal: media position, vertical: sensor
adjustment/adjustment by issuing commands.)
4) Communication
test
5) Abnormal
noise
6) Confirm that there are not any other errors.
10. Close the top cover.
Cutter Blade
Cutter Unit