3M C3266PW 用户手册
3M™ Multi-Touch Chassis Display User Guide
11
3M Touch Systems, Inc. Proprietary Information – TSD-39373 REV E
CHAPTER 1
Setting Up Your Multi-Touch Chassis Display
This chapter describes how to set up your 3M Touch Systems Multi-Touch Chassis
Display. You need to complete the following tasks:
Display. You need to complete the following tasks:
•
Unpack the components
•
Connect the video cable, touch display cables, and power cable
•
Power on the display and test your setup
•
If you are not running Windows® 7 (or Tablet PC), install MT7 software from the
enclosed CD.
enclosed CD.
System Requirements
The Multi-Touch Chassis Display requires a personal computer (PC). The requirements
for your PC are as follows:
for your PC are as follows:
•
Your PC must have an available USB or RS-232 serial communication (COM) port.
You connect the touch sensor cable to this communications port.
You connect the touch sensor cable to this communications port.
•
Your PC must have a video card and video driver already installed for the display. If
you need to install a video card or a video driver, refer to your computer
documentation for instructions.
you need to install a video card or a video driver, refer to your computer
documentation for instructions.
Note:
Before setting up your Multi-Touch Chassis Display, refer to the “Important
Safety Information” section at the beginning of this document.
Unpacking Your Touch Display
Carefully unpack the carton and inspect the contents. Your Multi-Touch Chassis Display
includes the following cables and accessories:
includes the following cables and accessories:
•
USB and RS-232 serial communication cables
•
DVI, HDMI, and VGA video cables
•
US, UK or EU power cables (as needed)
•
Hardware Kit -- 4 mounting brackets and (12) 8-32 screws