Hearth & Home Technologies MBK 用户手册

R

Page 10

   7004-187F  September 1, 2008

1.  Lift off cast top.  Remove 4 Phillips head screws from the 

heat shield.  Discard heat shield and save the screws. 
Figure 10A

2.  Remove 4 Phillips head screws from the rear shield, 2 on 

each side, lift shield off and set aside. Figure 10D

3.  Remove 1 bolt from each side of the flue transition. 

and retrieve nuts attached to bolts.  Use 3/8" and 7/16" 
wrenches. Figure 10B

4.  Turn vent to horizontal position. Inspect sealant to ensure 

a leak free application.  Figure 10C

5 

Manually snap off the knock-out section and discard.  See 
white outline in Figure 10A.

6.  Reattach the rear shield on both sides.
7.  Position the bracket (found in the component pack inside 

the firebox) over the opening on the rear shield.  Use 
2 screws removed in Step #1 to secure the bracket.  
Figure 10D

8.  Place cast top on the unit.

Discard Heat Shield

Knock Out 

Section

Attach 
bracket 
to rear 
shield

Bracket

2 screws on 

each side

Place Horizontal Flue Heat Shield over rear shield as shown 
in Figure 10E.  Secure with the remaining 2 screws removed 
in Step #1 under Reversing Flue Collar.

Secure

 Horizontal Flue Heat 

Shield

The flue collar is reversible for either a top or rear venting 
installation.  Accessory Horizontal Flue Heat Shield, Part 
HTSHLD-7006, is required in rear vent installations.  The 
stove is shipped with the flue collar in the top vent position.