Whirlpool W10259190B - SP 用户手册

Venting systems come in many varieties. Select the type best for 
your installation. Two examples of close-clearance installations are 
shown. Refer to the manufacturer’s instructions.

NOTE: The following kits for close-clearance alternate installations 
are available for purchase. Please see the “Assistance or Service” 
section to order.

■

Over-the-Top Installation: 

Part Number 4396028

■

Periscope Installation (For use with dryer vent to wall vent 
mismatch):

Part Number 4396037 - 0" (0 mm) to 18" (457 mm) mismatch

Part Number 4396011 - 18" (457 mm) to 29" (737 mm) 
mismatch

Part Number 4396014 - 29" (737 mm) to 50" (1.27 m) mismatch

The exhaust vent must be securely fastened to a noncombustible 
portion of the mobile home structure and must not terminate 
beneath the mobile home. Terminate the exhaust vent outside.

■

Select the route that will provide the straightest and most direct 
path outdoors. 

■

Plan the installation to use the fewest number of elbows and 
turns. 

■

When using elbows or making turns, allow as much room as 
possible. 

■

Bend vent gradually to avoid kinking. 

■

Use the fewest 90° turns possible.

■

Use the following vent system chart to determine type of vent 
material and hood combinations acceptable to use.

NOTE: Do not use vent runs longer than those specified in the 
Vent system chart. 

Exhaust systems longer than those specified will:

■

Shorten the life of the dryer.

■

Reduce performance, resulting in longer drying times and 
increased energy usage.

The vent system chart provides venting requirements that will help 
to achieve the best drying performance.

NOTE: Side and bottom exhaust installations have a 90º turn inside 
the dryer. To determine maximum exhaust length, add one 90º turn 
to the chart.

64ft (20 m)

58ft (17.7 m)

54 ft (16.5 m) 

48 ft (14.6 m)

44 ft (13.4 m)

38 ft (11.6 m)

35 ft (10.7 m)

29 ft (8.8 m)

27 ft (8.2 m)

21 ft (6.4 m)

1. Install exhaust hood. Use caulking compound to seal exterior wall 

opening around exhaust hood.

2. Connect vent to exhaust hood. Vent must fit inside exhaust hood. 

Secure vent to exhaust hood with 4" (102 mm) clamp.

3. Run vent to dryer location. Use the straightest path possible. 

See “Determine vent path” in “Plan Vent System.” Avoid 90º 
turns. Use clamps to seal all joints. Do not use duct tape, 
screws, or other fastening devices that extend into the 
interior of the vent to secure the vent, because they can catch 
lint.

WARNING

1. To avoid damaging the floor, use a large flat piece of cardboard 

from the dryer carton. Place cardboard under the entire back 
edge of the dryer.